[Close] 

Service Level Technician II - El Reno, OK - $19/hour

Full-time with benefits, $19. 00 per hour with overtime! Don't miss this opportunity!

The Caterpillar Global Power Systems Division, Oil & Gas, has an exciting opportunity for a Service Technician II, located inEl Reno, OK. In this position, you will provide rebuild and re-certification services for high pressure flow iron products.

Job Duties/Responsibilitiesmay include, but are limited to:

  • Create and review work orders
  • Assist with material check in / out
  • Disassemble, clean, recondition, inspect, assemble, test and paint service components
  • Provide guidance to service technicians on work flow, assignments and prioritization.
  • Visually inspect entire component for all indications of potential failure points.
  • Assist customers with certification documentation, iron loading, or any other service requests.
  • Participate in additional routine duties involving general housekeeping, non-standard service activities and any other service needs.
  • Removal and installation of components by following the appropriate service manual.

  • Determine which parts are reusable using pertinent Service or Parts information

  • Demonstrate proper use of available diagnostic equipment and special tools.

  • Understand and utilize exchange components when appropriate.

  • Familiarity with various exchange items offered by Kemper and evaluate price of exchange vs. cost of repair.

  • Documenting the work done on the equipment on the computer and utilizing Kemper specific service report software.

  • Complete work assignments within allotted time and secure and maintain appropriate licensing.

Note new wage scale -- $19 hour!!

PHYSICAL DEMANDS

The physical demands described here are representative of those that must be met by an employee to successfully perform the essential functions of this job.

The employee must have the ability to

  • Occasionally lift 50 pounds from floor to chest

  • Reach and use the arms with a full range of motion to retrieve stocked parts

  • Endure prolonged stooping, kneeling, crouching and squatting while performing mechanical operations

  • Exert push and pull forces with the arms to use various wrenches and tools

  • Endure prolonged forward and overhead arm positions while performing mechanical operations

  • Use the hands to grasp hand tools and parts and climb onto and operate equipment.

WORK ENVIRONMENT

The work environment characteristics described here are representative of those an employee may encounter while performing the essential functions of this job.

The employee must have the ability to

  • Regularly works outdoors around moving mechanical parts.

  • Tolerate exposure to weather extremes when working outside in conditions that include inclement weather, heat, cold, and humidity

  • Work in an environment where noise level may be loud at times

  • Tolerate exposure to small quantities of chemicals, dust, steam, high-pressure water, and high-speed rotating equipment.

  • Wear required protective or safety equipment.

BASIC REQUIREMENTS
  • Minimum 1-year experience with servicing high pressure flow iron
  • Technical training of equipment
  • Basic computer skills.
  • Ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals. Ability to compute rate, ratio, and percent and to draw and interpret bar graphs.
TOP CANDIDATES WILL ALSO HAVE
  • ASNT Level I/II inspector in Magnetic Particle/Ultrasonic Testing
  • Fork lift driver license
  • Basic written and verbal communication skills.
  • Dependable form of transportation
  • Prior experience with Kemper equipment.
  • Ability to apply common sense understanding to carry out detailed but uninvolved written or oral instructions.
  • Ability to deal with problems involving a few concrete variables in standardized situations.
  • Maintain good work habits and present a favorable business image towards customers served by the company.
  • Comply with all safety and company regulations.

This is full time position located in Sulphur, OK

Relocation is not offered for this position.

Note new wage scale -- $19 hour!!



Don't Be Fooled

The fraudster will send a check to the victim who has accepted a job. The check can be for multiple reasons such as signing bonus, supplies, etc. The victim will be instructed to deposit the check and use the money for any of these reasons and then instructed to send the remaining funds to the fraudster. The check will bounce and the victim is left responsible.

More Jobs

Speech Therapist - El Reno/Watonga
El Reno, OK Mercy
Assembly, Maintenance, Repair & Overhaul Techn...
Tulsa, OK General Electric
Equipment Technician (CWI) - Oklahoma City, OK
Oklahoma City, OK General Electric
Technician II, R&E
Oklahoma City, OK AAR CORP
AMO Technician (Drilling Services) - Oklahoma ...
Oklahoma City, OK General Electric
ARMO Technician -Various Shifts- (Drilling Ser...
Oklahoma City, OK General Electric